Heat back, and the vent checked free
Needing a second cycle for a single load is a fault, not a quirk, and every run wastes electricity while it lasts. We repair electric, gas and propane dryers and inspect the vent while we are there.
Dryer problems fall into three families, and identifying the family tells us how long the visit will take.
Drum turns, nothing warms
Electric models lose the element or a thermal fuse. Gas and propane lose the igniter or flame sensor. All routine repairs.
Damp after a full cycle
Restricted airflow, nearly every time. Every load costs twice the energy when the exhaust cannot clear, and lint in a hot duct is how most laundry fires begin.
Drum refuses to turn
The belt most often, though flattened rollers or a locked tensioner end the same way once the noise has gone on long enough.
Rumbling or screeching
Years of turning wear flats into the rollers and the tensioner wheel. Caught early the parts are cheap. Left too long they chew through the belt and then load the motor until it fails too.
Cutting out after a few minutes
The thermal fuse doing its job on an overheating machine. Look further back: either the air cannot move, or a thermostat has stuck closed.
Will not start at all
Something in the safety chain has opened: the door switch, the start button, or the fuse behind the back panel. Each gets checked with a meter instead of fitting all three and hoping.
Fuel type, model, and whether the drum turns. Electric and gas dryers fail differently from the first minute.
Both get measured, because one masks the other. A weak element behind a choked duct looks identical to a dead element.
Repair cost quoted in full, with the vent condition reported honestly whether or not it needs work.
Part fitted, duct cleared if needed, and a heat check run before we leave.
Dryer codes concern heat, airflow and moisture sensing more than anything else.
Vent restriction measured by the machine itself. The number is the percentage of airflow it has lost.
Heating element or thermistor. Either nothing warms, or the temperature readings make no sense.
Door position not confirmed. Switch or latch, depending on model year.
The temperature sensor reads open or short, and the controller cuts heat rather than risk it.
Main control fault. Sometimes recoverable with a power cycle, usually not.
Heater relay or element circuit open. The drum spins perfectly cold.
Power interrupted mid-cycle. Once is nothing. Repeatedly is worth investigating.
Sensor or control fault, usually with the cycle ending early.
Take vent codes seriously. Restricted airflow forces the machine to work harder for longer. That is how laundry fires start, and it is also why a freshly fitted element can burn out inside twelve months.
Give us a ring for the quickest answer, or leave your number and we will call back with the first available slot.
Basic vented machines, condenser units, heat-pump models and heavy-duty Speed Queen drums alike. Elements, igniters, belts and fuses for the common models travel with us.
Two runs to dry towels and we were ready to replace it. Duct was solid, element half gone. Both sorted in one visit.
Squealing loud enough to hear upstairs. Rollers and belt replaced, and it runs quietly again.
We cover every community on the list, including the older stock near the waterway where exhaust runs wander halfway across a basement before reaching daylight.
Leave three details and we will ring back with the earliest opening. The phone is quicker if the appliance cannot wait.
Open every day
7:00 a.m. – 11:00 p.m., weekends included
Call the office
(289) 673-1762Where we're based
239 Barrick Rd, Unit 10, Port Colborne, ON L3K 5Z5, Canada
Fill in three fields and the rest is on us.
Thank You!
Your message has been sent successfully. We'll get back to you shortly.
Your request has been sent. We'll call you back shortly to confirm your visit.
